Configure Debug Elsm-Port - Extreme Networks ExtremeWare Command Reference Manual

configure debug elsm-port

configure debug elsm-port <level> <port number>
Description
Configures debug tracing for Extreme Link Status Monitoring (ELSM) ports.
Syntax Description
level
port number
Default
None.
Usage Guidelines
To configure debug tracing for ELSM ports, use the following command:
configure debug elsm-port <level> <port number>
The levels provide the following information:
• Level 1 is information.
• Level 2 is trace, and is used to trace the path of code execution.
• Levels 3 and above are not used.
To disable debug tracing, set the level to 0.
To configure ELSM debug tracing for the entire system, use the following command:
configure debug elsm-system <level>
Example
The following command configures debug tracing of code execution (Level 2) for ELSM port 3 on the
switch:
configure debug elsm-port 2 3
History
This command was first available in ExtremeWare 6.2.2b134.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies the level of debug tracing:
• 0 - Level 0 disables debug tracing.
• 1 - Level 1 is information.
• 2 - Level 2 is trace, and is used to trace the path of code execution.
Levels 3 and above are not used. To disable debug tracing, set the level to 0.
Specifies the ports or slots and ports for which ELSM debug tracing is being
configured. May be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
configure debug elsm-port
1049