Configure Stpd Priority - Extreme Networks ExtremeWare Command Reference Manual

configure stpd priority

configure stpd <spanning tree name> priority <priority>
Description
Specifies the bridge priority of the STPD.
Syntax Description
spanning tree name
priority
Default
32,768.
Usage Guidelines
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
By changing the priority of the STPD, you can make it more or less likely to become the root bridge.
The range for the
Example
The following command sets the bridge priority of STPD1 to 16,384:
configure stpd stpd1 priority 16384
History
This command was first available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies an STPD name on the switch.
Specifies the bridge priority of the STPD.
parameter is 0 through 65,535. A setting of 0 indicates the highest priority.
priority
configure stpd priority
1019