Enable Isis Overload - Extreme Networks ExtremeWare Command Reference Manual

IGP Commands

enable isis overload

enable isis [level-2 | area <isis area identifier>] overload {at-startup}
{<seconds(1-86400)>}
Description
Enables the setting of the overload bit in the LSP originated by the system in the level 2 subdomain or
level 1 area.
Syntax Description
level-2
isis area identifier
at-startup
seconds(1-86400)
Default
The default setting is disabled.
Usage Guidelines
The option sets the overload bit at system startup time.
at-startup
The <
seconds(1-186400)>
specified, the bit is set until it is disabled. The range is 1 to 186,400 seconds.
Example
The following command enables IS-IS overload for the level 1 area a1 with a duration of 100 seconds:
enable isis area a1 overload 100
History
This command was first available in ExtremeWare v6.1.8 IS-IS tech release and subsequently
incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
1354
Specifies the level 2 subdomain.
Specifies a level 1 area.
Specifies that setting the overload bit is enabled at startup.
Specifies the duration of the overload.
parameter sets the duration of the overload bit. If the duration is not
ExtremeWare Software 7.3.0 Command Reference Guide