Configure Isis Add Area Address - Extreme Networks ExtremeWare Command Reference Manual

configure isis add area address

configure isis [level-2 | area <isis area identifier>] add <area address>
Description
Adds an IS-IS area address for a level 2 subdomain or a level 1 area.
Syntax Description
level-2
isis area identifier
area address
Default
N/A.
Usage Guidelines
At least one area address must be configured per area or subdomain, up to a maximum of three.
Configuring multiple area addresses can be temporarily useful when multiple areas are merged, or
when one area is split into multiple areas. Multiple area addresses enable you to remember an area
individually as needed.
If no area address is configured, the IS-IS process will not start.
Example
The following command adds an IS-IS area address for level 2 subdomains:
configure isis level-2 add 02
History
This command was first available in ExtremeWare v6.1.8 IS-IS tech release and subsequently
incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies level 2.
Specifies an area identifier.
Specifies an area address.
configure isis add area address
1261