Enable Iparp Refresh - Extreme Networks ExtremeWare Command Reference Manual

IP Unicast Commands

enable iparp refresh

enable iparp refreshenable iparp refresh
Description
Enables IP ARP to refresh its IP ARP entries before timing out.
Syntax Description
This command has no arguments or variables.
Default
Enabled.
Usage Guidelines
IP ARP refresh can only be disabled if IP forwarding is disabled. The purpose of disabling ARP refresh
is to reduce ARP traffic in a high node count layer 2 switching only environment.
Example
The following command enables IP ARP refresh:
enable iparp refresh
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
1222 ExtremeWare Software 7.3.0 Command Reference Guide