Show Elrp - Extreme Networks ExtremeWare Command Reference Manual

ESRP Commands

show elrp

show elrp {<vlan name> | detail}
Description
Displays ELRP information.
Syntax Description
vlan name
detail
Default
N/A.
Usage Guidelines
If you enter the
show elrp
• Total number of clients registered with ELRP
• ELRP packets transmitted
• ELRP packets received
If you enter the keyword, more detailed status information for VLANs in the master and
detail
pre-master states is displayed. If you enter a
that specific VLAN.
The additional table output for the
Client name Displays the name of the ELRP client.
VLAN Displays the name of the VLAN with ELRP enabled.
Interval Displays the configured interval. An interval of 3 indicates that ELRP PDUs are transmitted
every 3 seconds.
Count Lists the configured number of ELRP PDUs that are transmitted. The PDUs are transmitted at
the configured interval. This method of ELRP PDU transmission is used by ESRP in the
pre-master state. A count of 0 indicates continuous PDU transmission. If the Cyclic value is
Yes, the count is always 0.
Cyclic Indicates whether ELRP PDUs are being continuously sent. The column shows Yes for the
master VLAN because that VLAN is continuously sending ELRP PDUs for loop detection.
When a VLAN is in the pre-master state, it only sends three ELRP PDUs before changing to
master or slave. During this time the column shows No for that VLAN.
Pkts-Xmit Displays the number of ELRP PDUs transmitted.
Pkts-Rcvd Displays the number of ELRP PDUs received.
1112
Specifies an ESRP-enabled VLAN name.
Specifies detail for each switch in the ESRP VLAN.
command without a keyword, the command displays the:
vlan name
keyword or a specific VLAN name includes the following:
detail
, the command displays ELRP information for
ExtremeWare Software 7.3.0 Command Reference Guide