Configure Bgp Neighbor Route-Map-Filter - Extreme Networks ExtremeWare Command Reference Manual

BGP Commands

configure bgp neighbor route-map-filter

configure bgp neighbor [<ip address> | all] route-map-filter [in | out]
[none | <route map>]
Description
Configures a route map filter for a neighbor.
Syntax Description
ip address
all
in
out
none
route map
Default
N/A.
Usage Guidelines
The route map filter can be installed on the input or output side of the router. The route map is used to
modify or filter the NLRI information and the path attributes associated with it when exchanging
updates with the neighbor.
Example
The following command configures the route-map-filter filter for a neighbor based on the access profile
nosales:
configure bgp neighbor 192.168.1.22 route-map-filter in nosales
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
1420
Specifies an IP address.
Specifies all neighbors.
Specifies to install the filter on the input side.
Specifies to install the filter on the output side.
Specifies to remove the filter.
Specifies a route map.
ExtremeWare Software 7.3.0 Command Reference Guide