Configure Ospf Priority - Extreme Networks ExtremeWare Command Reference Manual

IGP Commands

configure ospf priority

configure ospf [area <area identifier> | vlan [<vlan name> | all]] priority
<priority>
Description
Configures the priority used in the designated router-election algorithm for one or all OSPF interface(s)
for all the interfaces within the area.
Syntax Description
area identifier
vlan name
all
priority
Default
The default setting is 1.
Usage Guidelines
The range is 0 through 255, and the default setting is 1. Setting the value to 0 ensures that the router is
never selected as the designated router or backup designated router.
Example
The following command sets the switch to not be selected as the designated router:
configure ospf area 1.2.3.4 priority 0
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
1284
Specifies an OSPF area.
Specifies a VLAN name.
Specifies all VLANs.
Specifies a priority range. The range is 0 through 255.
ExtremeWare Software 7.3.0 Command Reference Guide