Extreme Networks ExtremeWare Command Reference Manual page 1119

No-count ports on the System:
The following command displays detailed ESRP status information for the VLANs on the switch:
show esrp detail
It produces output similar to the following:
VLAN Interface(Layer 2): demo_esrp
Priority:
Active Ports:
Internal Ports:
Tracked Rt/Ping/LSP:
Tracked Ports:
Tracked Diag:
Tracked Env:
Tracked RIP:
Tracked OSPF:
Tracked BGP:
Tracked LSP:
ELRP in Premaster(Int, Cnt):Enabled(1, 3)
ELRP in Master(Int):
Election Algorithm:
Group:
Hello Timer:
Esrp Nbr Timeout:
Premaster Timeout:
State:
State Trans Counters:
Host (Direct-Attach) ports : None
No-count ports: None
Restart Ports: None
Tracked VLANs: None
Tracked Ip Routes: None
Tracked Pings/Freq/N_miss:
192.12.1.1/5/2*
Neighbours:
[1]
History
This command was first available in ExtremeWare 4.0.
This command was updated to support ELRP data in ExtremeWare 6.2.2b134 and ExtremeWare 7.1.0.
ELRP data is not displayed in ExtremeWare 7.0.
This command was updated to support ESRP hitless failover statistics in ExtremeWare 7.1.1.
ExtremeWare Software 7.3.0 Command Reference Guide
0 (Priority In Use: 0)
2
0
0
0
-
-
-
-
-
None
Enabled(1)
ports-track-priority-mac
0
2
6
6
Enabled(Slave) on Mon Jun 2 10:09:48 2003
ToMaster:(1)
Nbr Active Ports:
Nbr Internal Ports:
Nbr Tracked Rt/Ping/LSP:
Nbr Tracked Ports:
Nbr Priority:
Nbr MacID:
Nbr HelloTimer:
Nbr ESRP State:
ToPremaster:(1) ToSlave:(2)
3
0
0
0
0
00:01:30:33:28:00
2
Master
show esrp
1119