Configure Rip Vlan Import-Filter - Extreme Networks ExtremeWare Command Reference Manual

configure rip vlan import-filter

configure rip vlan [<vlan name> | all] import-filter [<access profile> |
none]
Description
Configures RIP to ignore certain routes received from its neighbor.
Syntax Description
vlan name
all
access profile
none
Default
N/A.
Usage Guidelines
Configures an import filter policy, which uses an access profile to determine which RIP routes are
accepted as valid routes. This policy can be combined with the trusted neighbor policy to accept
selected routes only from a set of trusted neighbors.
Using the none mode, the access profile can contain a combination of permit and deny entries. Each
entry must have a permit or deny attribute. The operation is compared with each entry in the list. When
a match is found, the operation is either permitted or denied, depending on the configuration of the
matched entry. If no match is found, the operation is implicitly denied.
Example
The following command configures the VLAN backbone to accept selected routes from the access profile
nosales:
configure rip vlan backbone import-filter nosales
History
This command was first available in ExtremeWare 4.0.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies a VLAN name.
Specifies all VLANs.
Specifies an access-profile name.
Specifies to check the access profile for permit and deny attributes.
configure rip vlan import-filter
1325