Configuring Kompella Mpls L2Vpn - 3Com 3C13636 Configuration Manual

Router 3000 ethernet family

Hide thumbs Also See for 3C13636:

Table of Contents

3Com Router 3000 Ethernet Family

Configuration Guide

The conditions for a Martini connection to go up are:

The two CE interfaces are in UP state.

Two tunnels (GRE or LSP, one in each direction) have been established between

The encapsulation type for the two CE interfaces is consistent and supported in

current MPLS L2VPN.

LDP remote session has been set up between two PEs and is in UP state.

To establish a GRE or LSPF tunnel, you have to specify the route to the peer PE, so

it is required to configure IGP (for example, OSPF) on the routers along the route,

4.7.4 Configuring Kompella MPLS L2VPN

I. Network requirements

CE and PE are connected through ATM interface. Create a connected VPN, in which

three CEs are contained: CE-A, CE-B and CE-C. Since two CEs will be added in later

expansion, the CE range for each CE is set to 4 and VCs have been allocated for the

future two CEs. In the future expansion, only configuring the PE for which new CEs are

added is only required.

II. Network diagram

Local connection

Figure 4-7 Network diagram for Kompella MPLS VPN

III. Configuration procedure

Configure PE-A

# Configure LSR ID; enable MPLS L2VPN.

[3Com] mpls lsr-id 192.1.1.1

Remote connection

3Com Corporation

Chapter 4 MPLS L2VPN Configuration

Remote connection

Table of Contents

3c13636-us - router 3036 3000 series