Configuring Source Address For Hwtacacs Packets Sent By Nas - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
The primary and secondary accounting servers cannot use the same IP address.
Otherwise, the system will prompt unsuccessful configuration. The default port number
is 49.
The default IP address of TACACS accounting server is 0.0.0.0.
If you execute this command repeatedly, the new settings will replace the old settings.
You can remove a server that cannot be removed otherwise, only when it is not used by
any active TCP connection for sending accounting packets.
II. Enabling stop-accounting packet retransmission
Perform the following configuration in HWTACACS view.
Table 2-37 Configure stop-accounting packet retransmission
Enable stop-accounting packet retransmission
and set the allowed maximum number of
transmission attempts.
Disable stop-accounting packet retransmission.
By default, stop-accounting packet retransmission is enabled, and the allowed
maximum number of transmission attempts is 100.

2.4.5 Configuring Source Address for HWTACACS Packets Sent by NAS

Perform the following configuration.
Table 2-38 Configure the source address to be carried in HWTACACS packets sent by
the NAS
Configure the source address to be carried in
HWTACACS
NAS(HWTACACS view).
Delete the configured source address to be carried
in the HWTACACS packets sent by the NAS
(HWTACACS view).
Configure the source address to be carried in the
hwtacacs packets sent by the NAS(System view).
Cancel the configured source address to be
carried in the hwtacacs packets sent by the
NAS(System view).
By default, no source address is specified and the source address to be carried in a
packet is the address of the interface where the packet is sent.
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Operation
Operation
packets sent
3Com Corporation
2-33
retry
retry-times
undo retry stop-accounting
by the nas-ip ip-address
undo nas-ip
hwtacacs nas-ip ip-address
undo hwtacacs nas-ip
Configuration
Command
stop-accounting
Command