Setting Timers Regarding Radius Server - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Table 2-26 Configure source address for the RADIUS packets sent by the NAS
Configure the source address to be carried in the
RADIUS packets sent by the NAS(RADIUS view).
Cancel the configured source address to be
carried in the RADIUS packets sent by the
NAS(RADIUS view).
Configure the source address to be carried in the
RADIUS packets sent by the NAS(System view).
Cancel the configured source address to be
carried in the RADIUS packets sent by the
NAS(System view).
You can use either command to bind a source address with the NAS.
By default, no source address is specified and the source address of a packet is the
address of the interface where it is sent.

2.3.12 Setting Timers Regarding RADIUS Server

I. Setting the response timeout timer
If the NAS receives no response from the RADIUS server after sending a RADIUS
request (authentication/authorization or accounting request) for a period of time, the
NAS has to resend the request, thus ensuring the user can obtain the RADIUS service.
You can use the following commands to set the response timeout timer.
Perform the following configuration in RADIUS view.
Table 2-27 Set the response timeout timer
Set the response timeout timer.
Restore the default response timeout timer.
By default, the response timeout timer for the RADIUS server is set to three seconds.
II. Setting the quiet timer for the primary RADIUS server
Perform the following configuration in RADIUS view.
Table 2-28 Configure the quiet timer for the primary RADIUS server
Configure the quiet timer for the primary RADIUS server.
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Operation
Operation
Operation
3Com Corporation
2-27
Command
nas-ip ip-address
undo nas-ip
radius nas-ip ip-address
undo radius nas-ip
Command
timer response-timeout seconds
undo timer response-timeout
Command
timer quiet minutes
Configuration