3Com Router 3000 Ethernet Family
Configuration Guide
I. Creating a DVPN class and entering its view
Use these commands to create a DVPN class and enter its view, or remove an existing
DVPN class. Note that a DVPN class in use cannot be removed.
Perform the following configuration in system view.
Table 4-18 Create a DVPN class
Create a DVPN class and enter its view
Remove a DVPN class
No DVPN class is configured by default.
II. Configuring the public IP address of the DVPN server
The public IP address here refers to the fixed public IP address assigned to the DVPN
server.
Perform the following configuration in DVPN class view.
Table 4-19 Configure the public IP address of the DVPN server
Configure the public IP address of the DVPN server
Remove the public IP address of the DVPN server
No public IP address of the DVPN server is configured by default.
III. Configuring the private IP address of the DVPN server
The private IP address here refers to the IP address of the tunnel interface through
which the DVPN server accesses a DVPN domain. This configuration is optional.
During registration, when a client configured with the private IP address of the DVPN
server receives a registration response message from the server, it compares the
private IP address of the server contained in the response message with that
configured on it. If the two private IP addresses are not the same, the client tears down
the connection.
Perform the following configuration in DVPN class view.
Table 4-20 Configure the private IP address of the DVPN server
Configure the private IP address of the DVPN server
Operation
Operation
Operation
3Com Corporation
4-18
Command
dvpn class dvpn-class-name
undo dvpn class
Command
public-ip ip-address
undo public-ip ip-address
Command
private-ip ip-address
Chapter 4 DVPN