Setting Timers Regarding Tacacs Server - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Operation
Restore the default unit
of data flows destined for
the TACACS server.
The default data flow unit is byte.

2.4.9 Setting Timers Regarding TACACS Server

I. Setting the response timeout timer
Since HWTACACS is implemented based on TCP, server response timeout or TCP
timeout may terminate the connection to the TACACS server.
Perform the following configuration in HWTACACS view.
Table 2-42 Set the response timeout timer
Set the response timeout time.
Restore the default setting.
The default response timeout timer is set to five seconds.
II. Setting the quiet timer for the primary TACACS server
Perform the following configuration in HWTACACS view.
Table 2-43 Set the quiet timer for the primary TACACS server
Set the quiet timer for the primary
TACACS server.
Restore the default setting.
By default, the primary TACACS server must wait five minutes before it can resume the
active state.
III. Setting a realtime accounting interval
The setting of real-time accounting interval is indispensable to real-time accounting.
After an interval value is set, the NAS transmits the accounting information of online
users to the RADIUS accounting server at intervals of this value.
Perform the following configuration in HWTACACS view.
undo data-flow-format [ data | packet ]
Operation
Operation
3Com Corporation
2-35
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Command
Command
timer response-timeout seconds
undo timer response-timeout
Command
timer quiet minutes
undo timer quiet
Configuration