3Com Router 3000 Ethernet Family
Configuration Guide
By default, the keepalive function of GRE is disabled; seconds is set to 10 and times to
3.
3.3 Displaying and Debugging GRE
Upon the completion of the above configurations, execute the display command in any
view to view their running state and to verify the effect of the configurations. The
debugging command can be used in user view.
Table 3-9 Display and debug GRE
Display
interfaces.
Enable tunnel information debugging.
3.4 Typical Configuration Examples of GRE
I. Network requirements
Two subnets running IP, Group1 and Group2, are interconnected by using GRE
between the routers of 3Com1 and 3Com2.
II. Network diagram
IP
Group1
Figure 3-8 Network diagram of GRE application
III. Configuration procedure
1)
Configure 3Com1:
# Configure interface Ethernet 0/0/0.
[3Com1] interface ethernet 0/0/0
[3Com1-Ethernet0/0/0] ip address 10.1.1.1 255.255.255.0
[3Com1-Ethernet0/0/0] quit
# Configure interface Serial 0/0/0 (physical interface of tunnel).
[3Com1] interface serial 1/0/0
[3Com1-Serial1/0/0] ip address 192.13.2.1 255.255.255.0
Operation
operating
state
of
Ethernet0/0/0
10.1.1.1/24
Quidway 1
Tunnel1/0/0
Serial1/0/0
192.13.2.1/24
3Com Corporation
Chapter 3 Configuration of GRE
tunnel
display interface tunnel number
debugging tunnel
Ethernet0/0/0
10.1.3.1/24
Internet
Tunnel2/0/0
Serial2/0/1
131.108.5.2/24
3-9
Command
IP
Group2
Quidway 2