3Com 3C13636 Configuration Manual page 1018

3Com Router 3000 Ethernet Family
Configuration Guide
Table 2-13 Set/remove the attributes concerned with a specified user
Set a password for a specified user.
Remove the password set for the
specified user.
Set the state of the specified user.
Remove the state of the specified user.
Set a service type for the specified user.
Cancel a service available for users.
Set a priority level for the user.
Restore the default priority level.
Set the directory that can be accessed if
the user is an FTP user.
Restore the default directory that can be
accessed if the user is an FTP user.
Set the attributes of callback number
and call number of PPP users.
Restore the default callback number
and call number of PPP users.
By default, no service is authorized to users. The default user priority level is 0.
Note:
If the configured authentication method requires username and password (including
local, RADIUS, and HWTACACS authentication), your user priority determines
which level of commands you can access after logging onto the system. If the
authentication method is none or only requires password, your interface priority
determines which level of commands you can access.
The ciphertext password set by the password cipher command is 64 characters
long in V 2.41 RT-0011 or later versions, but it is only 24 characters long in ealier
versions. As this may cause password loss when you downgrade V 2.41 RT-0011 or
later versions to an ealier version of V 2.41 RT-0011, you are recommended to back
up your configuration file before doing that.
Operation
3Com Corporation
2-17
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Command
password { simple | cipher } password
undo password
state { active | block }
undo state { active | block }
service-type { dvpn | telnet | ssh |
terminal | pad }
undo service-type { dvpn | telnet | ssh
| terminal | pad }
level level
undo level
service-type
directory]
undo service-type ftp [ ftp-directory ]
service-type ppp [ callback-nocheck |
callback-number
call-number
[ subcall-number ] ]
undo service-type
[ callback-nocheck | callback-number
| call-number ]
Configuration
ftp [ ftp-directory
callback-number
call-number
ppp
|