3Com 3C13636 Configuration Manual page 977

3Com Router 3000 Ethernet Family
Configuration Guide
III. Configuration procedure
1) Configure PE-A:
# Globally enable MPLS.
[3Com] mpls lsr-id 172.1.1.1
[3Com] mpls
# Globally enable MPLS L2VPN.
[3Com] mpls l2vpn
# Configure the interface SERIAL 0/0/0.
[3Com] interface serial0/0/0
[3Com-Serial0/0/0] link-protocol ppp
# Configure the interface SERIAL 1/0/0.
[3Com] interface serial 1/0/0
[3Com-Serial1/0/0] link-protocol ppp
# Configure the interface SERIAL 2/0/0.
[3Com] interface serial 2/0/0
[3Com-Serial2/0/0] link-protocol ppp
# Enable MPLS on the interface SERIAL 3/0/0.
[3Com] interface serial 3/0/0
[3Com-Serial3/0/0] link-protocol ppp
[3Com-Serial3/0/0] mpls
# Configure a local connection.
[3Com] ccc local-conn interface serial0/0/0 outgoing-interface serial2/0/0
# Configure a static LSP, with the out-label 100 and the outgoing interface SERIAL
3/0/0.
[3Com] mpls
[3Com-mpls]
outgoing-interface serial3/0/0 out-label 100 pre 2 metric 3
# Configure a static LSP, with the in-label 201 and the incoming interface SERIAL 3/0/0.
[3Com-mpls] static-lsp egress PEB-PEA l2vpn incoming-interface serial3/0/0
in-label 201
# Configure a remote connection.
[3Com] ccc remote-connection interface serial3/0/0 transmit-lsp PEA-PEB
receive-lsp PEB-PEA
2) Configure PE-B:
# Globally enable MPLS.
[3Com] mpls lsr-id 10.0.0.1
static-lsp ingress
3Com Corporation
4-17
Chapter 4 MPLS L2VPN Configuration
PEA-PEB destination 10.0.0.0 l2vpn