Configuring Policy - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
interfaces, virtual Ethernet interfaces, and subinterfaces. Note that CBQ can be
configured on ATM PVCs.
LR cannot be configured in a child policy.
committed-information-rate can be less than 8000 in an embedded child policy

3.6.4 Configuring Policy

I. Defining the Policy and entering the Policy View
Policy mapping defines the traffic behavior of each class in the policy. Each traffic
behavior is composed of a group of features, including EF, AF, WFQ, TP, TS, WRED
and label.
Perform the following configurations in the system view.
Table 3-52 Define the policy and enter the policy view
Define the policy and enter the policy view
Delete the specified policy
The policy name should not be that of the policies pre-defined by the system.
When creating the policy, the default has the default-class as the default class, which
associates with be behavior.
If this policy is applied on an interface, it cannot be deleted. The user must remove the
application of this policy on the interface and then delete the policy with the undo qos
policy command.
II. Specifying the Traffic Behavior for the Class in the Policy
Perform the following configurations in the policy view.
Table 3-53 Specify the traffic behavior for the class in the policy
Specify the traffic behavior for the class
in the policy
Remove the application of the specified
class in the policy
tcl-name: Class name. It must be that of the defined class, the system-defined or
user-defined class.
behavior-name: It must be that of the defined behavior, the system-defined or
user-defined behavior.
Operation
Operation
3Com Corporation
3-32
Chapter 3 Congestion Management
Command
qos policy policy-name
undo qos policy policy-name
Command
classifier tcl-name
behavior-name
undo classifier tcl-name
behavior