Configure Rip - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
[3Com-luser-userb] password simple usera
[3Com-luser-userb] service-type ppp
[3Com-luser-userb] quit
# Configure RS-DCC and MP on the dialer 0 interface.
[3Com] interface Dialer0
[3Com-Dialer0] link-protocol ppp
[3Com-Dialer0] ppp mp
[3Com-Dialer0] ip address 20.0.0.2 255.255.255.0
[3Com-Dialer0] undo dialer enable-circular
[3Com-Dialer0] dialer user userA
[3Com-Dialer0] dialer-group 1
[3Com-Dialer0] dialer bundle 1
[3Com-Dialer0] dialer number 8810052
[3Com-Dialer0] ppp authentication-mode pap
[3Com-Dialer0] ppp pap local-user usera password simple usera
[3Com-Dialer0] standby routing-group 1
# Configure dial parameters on interface BRI 0/0/0.
[3Com] interface bri 0/0/0
[3Com-bri0/0/0] dialer bundle-member 1
[3Com-bri0/0/0] ppp authentication-mode pap
[3Com-bri0/0/0] ppp pap local-user usera password simple usera
# Configure interface Serial 1/0/0 and encapsulate it with X.25.
[3Com-Bri0/0/0] interface serial 1/0/0
[3Com-Serial1/0/0] link-protocol x25 dte ietf
[3Com-Serial1/0/0] x25 x121-address 20
[3Com-Serial1/0/0] x25 map ip 10.0.0.1 x121-address 10 broadcast
[3Com-Serial1/0/0] ip address 10.0.0.2 255.0.0.0
# Configure a loopback interface.
[3Com-Serial1/0/0] interface loopback1
[3Com-Loopback1] ip address 30.0.0.1 255.0.0.0
[3Com-Loopback1] quit

# Configure RIP.

[3Com] rip
[3Com-rip] network 10.0.0.0
[3Com-rip] network 20.0.0.0
[3Com-rip] quit
3Com Corporation
2-11
Chapter 2 Dynamic Routing Standby