3Com 3C13636 Configuration Manual page 1319

3Com Router 3000 Ethernet Family
Configuration Guide
Table 3-10 Configure custom-list under network layer protocol
Configure custom-list under network
layer protocol
Delete the relative classifying rule of
group-number
II. Configuring custom-list according to the ingress interfaces of packets
Set an interface-based classifying rule. Repeatedly using this command can add rules
to a cql-index.
Perform the following configuration in system view.
Table 3-11 Configure custom-list based on interface
Configure custom-list based on the
incoming interface of packets
Delete the relative classifying rule of
group-number
III. Configuring default queue
Designate a default queue for those packets matching no rules.
Perform the following configuration in system view.
Table 3-12 Configure default queue
Configure default queue
Restore the default value of default
queue
We can define several rules for a custom-list and apply the rules to an interface. When
a packet is treated by the interface (the packet needs to be sent out via this interface),
the system will match this packet along rule chain; if it matched with a certain rule, then
it will enter the corresponding queue and the matching is finished, otherwise, the packet
will enter default queue.
The default value of default queue is 1.
Operation
Operation
Operation
3Com Corporation
3-13
Chapter 3 Congestion Management
Command
qos cql cql-index
protocol-name queue-key
queue queue-number
undo qos cql cql-index protocol
protocol-name [ queue-key key-value ]
Command
qos cql cql-index inbound-interface
interface-type interface-number queue
queue-number
undo qos cql
inbound-interface
interface-number
Command
qos cql cql-index
queue-number
undo qos cql cql-index default-queue
protocol
key-value
cql-index
interface-type
default-queue