3Com Router 3000 Ethernet Family
Configuration Guide
II. Configuring IKE negotiation mode
Perform the following configuration in IKE-peer view.
Table 8-9 Configure negotiation mode
Configure IKE negotiation mode.
Restore the default IKE negotiation
mode.
By default, the main mode is adopted.
Note:
If the IP address of one end of a security tunnel is dynamic, you must adopt the
aggressive mode for IKE negotiation.
III. Configuring pre-shared key
Perform the following configuration in IKE-peer view.
Table 8-10 Configure pre-shared key
Configure a pre-shared key for IKE negotiation.
Remove the pre-shared key used in IKE negotiation.
IV. Configuring ID type in IKE negotiation
Perform the following configuration in IKE-peer view.
Table 8-11 Configure ID type in IKE negotiation
Select ID type in the IKE negotiation.
Restore the default ID type in the IKE negotiation.
By default, IP address is taken as the ID in IKE negotiation.
Operation
Operation
Operation
3Com Corporation
8-8
Chapter 8 IKE Configuration
Command
exchange-mode { aggressive | main }
undo exchange-mode
Command
pre-shared-key key
undo pre-shared-key
Command
id-type { ip | name }
undo id-type