Displaying And Debugging Ipsec; Displaying And Debugging Over Ipsec Module On V 2.41 Platform - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide

7.3 Displaying and Debugging IPSec

7.3.1 Displaying and Debugging over IPSec Module on V 2.41 Platform

I. Displaying and debugging IPSec configuration
After the above configuration, execute display command in any view to display the
running of the IPSec configuration, and to verify the effect of the configuration.
Execute debugging command in user view for the debugging of IPSec configuration.
Table 7-31 Display and debug IPSec
Display Security Association related
information
Display statistical information on
IPSec processed packet
Display IPSec proposal
Display IPSec policy
Display IPSec policy template
Display
specified or all DPD structures
Enable IPSec debugging function
Disable IPSec debugging function
Enable IKE DPD debugging
Disable IKE DPD debugging
II. Clearing IPSec packet statistical information
This command clears IPSec packet statistical information. All statistical information is
set to zero.
Perform the following configuration in the user view.
Operation
information about
3Com Corporation
display ipsec sa [ brief | remote ip-address
| policy policy-name [ seq-number ] |
duration ]
display ipsec statistics
display ipsec proposal [ proposal-name ]
display ipsec policy [ brief | name
policy-name [ seq-number ] ]
display ipsec policy-template [ brief |
name policy-name [ seq-number ] ]
the
display ike dpd [ dpd-name ]
debugging ipsec { all | sa | packet [ policy
policy-name [ seq-number ] | parameters
ip-address protocol spi-number ] | misc }
undo debugging ipsec { all | sa | packet
[ policy policy-name [ seq-number ] |
parameters
spi-number ] | misc }
debugging ike dpd
undo debugging ike dpd
7-27
Chapter 7 IPSec Configuration
Command
ip-address protocol