Disconnecting An L2Tp Connection - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Table 2-8 Configure a username and password
Configure a user name and password (in system
view).
Delete the current setting (in system view).
Configure local user password (in local user
view).
By default, no local username and password are configured at the LAC side.
II. Configuring PPP user authentication mode
Perform the following configuration in interface or virtual template interface view.
Table 2-9 Configure/cancel PPP user authentication mode
Configure a PPP user authentication
mode.
Disable PPP user authentication.
The interface where you configure local authentication must be the one connected to
users.
III. Configuring a PPP domain user and an authentication scheme
Table 2-10 Configure a PPP domain user and an authentication scheme
Create an ISP domain and enter its view (in
system view).
Delete the specified ISP domain (in system
view.
Configure the local authentication scheme for
the PPP domain user. (in ISP domain view).

2.2.9 Disconnecting an L2TP Connection

A connection can be disconnected for one of these reasons: no user is present, fault
occurs on the network, or the administrator requests to do so.
Operation
Operation
Operation
3Com Corporation
2-11
Chapter 2 Configuration of L2TP
local-user username
undo local-user username
password { simple | cipher }
password
Command
ppp authentication-mode { chap | pap }
{ call-in | domain isp-name }
undo ppp authentication-mode
Command
domain { isp-name | default
{ disable | enable isp-name } }
undo domain isp-name
scheme local
Command