Lns Configuration - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Configure the username and password
for PAP authentication
III. Enabling/disabling the LAC client to set up L2TP tunnel
Perform the following configuration in virtual template interface view.
Table 2-18 Enable/disable the LAC client to set up L2TP tunnel
Enable the LAC client to set up L2TP
tunnel
Disable the LAC client to set up L2TP
tunnel
By default, the LAC client is disabled to set up L2TP tunnel.

2.3 LNS Configuration

In LNS configuration task list, L2TP must be enabled and L2TP group must be created
before any other functions can be configured. Regarding the configuration of L2TP
supporting multi-instance, no configurations can become valid unless the L2TP
multi-instance function is enabled. For detailed introduction to related commands of
PPP and Virtual-Template, refer to corresponding chapters and sections.
The major configuration tasks on LNS side include:
Enable L2TP (required)
Enable L2TP multi-instance function (optional)
Create L2TP group (required)
Create virtual template (required)
Set the parameters for call receiving (required)
Set tunnel authentication and password (optional)
Set the transmission mode of AVP data (optional)
Set Hello interval in the tunnel (optional)
Configure mandatory local CHAP authentication (optional)
Configure mandatory LCP renegotiation (optional)
Set local address and assigned address pool (the former is required and the latter
is optional.)
Set user name and password and configure user authentication (optional)
Disconnect tunnel by force(optional)
Set the flow control function of tunnel (optional)
Operation
Operation
3Com Corporation
2-15
Chapter 2 Configuration of L2TP
Command
ppp pap local-user
password { simple | cipher } password
Command
l2tp-auto-client enable
undo l2tp-auto-client enable
user-name