3Com 3C13636 Configuration Manual page 1330

3Com Router 3000 Ethernet Family
Configuration Guide
Table 3-34 Define a traffic behavior and enter traffic behavior view.
Define a traffic behavior and enter traffic
behavior view.
Delete a traffic behavior
behavior-name: Name of the traffic behavior. It is not the name of the traffic behavior
pre-defined by the system.
II. Configuring AF and minimum available bandwidth
Perform the following configurations in traffic behavior view.
Table 3-35 Configure AF and minimum available bandwidth
Configure AF and minimum available
bandwidth
Delete the configuration
This behavior can apply only in output direction of an interface or ATM PVC.
The same traffic behavior must use the same standard to configure queue ef and
queue af, either bandwidth or percentage.
When the service traffic sent to the network from an application is below the specified
value, AF ensures a low drop priority. AF has four classes, each containing up to three
levels of drop precedence.
III. Configuring ef and maximum bandwidth
Perform the following configurations in traffic behavior view.
Table 3-36 Configure ef and maximum bandwidth
Configure ef and maximum
bandwidth
Delete the configutation
In traffic behavior view, this command cannot be used along with queue af,
queue-length and wred.
This command cannot be used for default-class.
Operation
Operation
Operation
3Com Corporation
Chapter 3 Congestion Management
traffic behavior behavior-name
undo traffic behavior behavior-name
queue af bandwidth { bandwidth | pct
percentage }
undo queue af
Command
queue ef bandwidth
committed-burst-size ] | pct percentage [ cbs_ratio
ratio] }
undo queue ef
3-24
Command
Command
{ bandwidth [ cbs