Displaying And Debugging Aaa And Radius/Hwtacacs Protocols - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Note:
To allow a TACACS user to change its password, you must ensure that this function is
enabled on the TACACS server in addition to the TACACS client.
This function does not work with Cisco Security ACS V3.1 (TACACS Server).
2.5 Displaying and Debugging AAA and RADIUS/HWTACACS
Protocols
After the above configuration, execute the display commands in any view to view the
running of the AAA and RADIUS/HWTACACS configurations and to check the
configuration effect. Execute the reset commands in user view to reset the
configurations. Execute the debugging commands in user view for debugging.
Table 2-47 Display and debug the AAA protocol
Display
information of the specified or
all the ISP domains.
Display related information of
user's connection.
Display related information of
the local user
Table 2-48 Display and debug the RADIUS protocol
Display the specified or all the RADIUS
schemes or display the statistics about
RADIUS.
Display
packets.
Display
stop-accounting packets in the buffer.
Enable RADIUS packet debugging.
Operation
the configuration
Operation
the statistics on RADIUS
information on
3Com Corporation
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Command
display domain [ isp-name ]
display connection [ domain isp-name |
hwtacacs-scheme hwtacacs-scheme-name | ip
ip-address | mac mac-address | radius-scheme
radius-scheme-name | ucibindex ucib-index |
user-name user-name ]
display local-user [ domain isp-name |
service-type { pad | telnet | ssh | terminal | ftp |
ppp } | state { active | block } | user-name
user-name ]
display radius [ radius-scheme-name |
statistics ]
display radius statistics
display
{ radius-scheme radius-server-name |
the
session-id session-id | time-range
start-time
user-name }
debugging radius packet
2-37
Configuration
Command
stop-accounting-buffer
stop-time | user-name