Basic Portal Configuration Tasks - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
The portal-enabled Ethernet interface is configured with a legal IP address.
The portal server and the RADIUS server are installed and configured properly.
With re-DHCP authentication, the router is configured as a DHCP relay, and the
DHCP server is installed and configured properly.
If the portal server, RADIUS server, and DHCP server employ CAMS, refer to
Comprehensive Access Management Server Portal User Manual for information about
CAMS installation and configuration.

3.2.2 Basic Portal Configuration Tasks

The following table describes the basic portal configuration tasks.
Table 3-1 Basic portal configuration tasks
Enter system view
Set the portal service type
to normal
Configure a portal server
Configure
operating mode
Configure authentication
network segments
Enable
authentication
To do... Use the command...
system-view
portal
normal
portal
server-name
ip-address
key-string | port port | url
url-string } *
the portal portal method { direct |
redhcp }
portal
ip-address
interface
interface-num
portal
fast-authentication
fast portal
server
user-name
password password
3Com Corporation
service-type
server
{ ip
| key
auth-network
net-mask
interface-type
server-name
name
3-4
Chapter 3 Portal Configuration
Remarks
—
Optional.
The default portal service
type is normal portal
mode.
Required. By default, no
portal server
configured. When a portal
server is configured, by
default, key-string
huawei, port is 50100,
and url-string is the IP
address string prefixed
with http://.
Optional.
The default portal
operating mode is direct
authentication. For
application supporting
portal authentication for
non-directly connected
network segments, you
can configure direct
authentication only.
Required
Optional.
is
is
an