3Com 3C13636 Configuration Manual page 1014

3Com Router 3000 Ethernet Family
Configuration Guide
Remove the accounting scheme used by
the domain
By default, no separate authentication, authorization, or accouting scheme is available.
Note that:
1) If both separate and bundled authentication, authorization, and accounting
schemes are configured, the separate authentication, authorization, and
accounting schemes are preferred.
2) Since RADIUS and local schemes do not support the separate of authentication
and authorization, pay attention to the following when configuring authentication
and authorization:
If you configure the scheme radius-scheme or scheme local command for a
domain without configuring the authentication command:
a. If you have configured the authorization none command, the authorization
information returned by the RADIUS and local schemes are still valid.
b. If you have configured the authorization hwtacacs command, the
HWTACACS scheme will be employed for authorization.
If you configure both the scheme radius-scheme or scheme local command and
the authentication hwtacacs-scheme command, the HWTACACS scheme will
be employed for authentication, but no authorization will be performed.
III. Configuring the ISP domain state
Every ISP has active/block states. If an ISP domain is in active state, the users in it can
request for network service, while in block state, its users cannot request for any
network service, which will not affect the users already online. An ISP is in the active
state when it is first created. Users in the domain are allowed to request network
service.
Perform the following configuration in ISP domain view.
Table 2-7 Configure the ISP domain state
Configure the ISP domain state.
By default, an ISP domain is active when it is created.
IV. Setting an access limit
You can specify the maximum number of users that an ISP domain can accommodate
by setting an access limit. For any ISP domain, there is no access limit by default.
Operation
Operation
3Com Corporation
2-13
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Command
undo accounting
Command
state { active | block }
Configuration