Enabling/Disabling Flow Control Function Of Tunnel; Displaying And Debugging L2Tp - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Table 2-30 Disconnect a connection by force
Disconnect a tunnel
Disconnect a session
Disconnect a user

2.3.14 Enabling/Disabling Flow Control Function of Tunnel

This configuration can enable/disable the simple flow control function on a tunnel.
These configurations are optional on LAC side.
Perform the following configuration in L2TP group view.
Table 2-31 Enable/disable flow control function of a tunnel
Enable flow control function of a tunnel.
Disable flow control function of a tunnel.
By default, the flow control function of tunnels is disabled.

2.4 Displaying and Debugging L2TP

After performing the above configuration tasks, execute display commands in any view
to view the running status of L2TP configurations, and to verify the configuration effect.
The debugging commands can be used in user view.
Table 2-32 Display and debug L2TP
Display information about the current
L2TP users
Display information about the current
L2TP tunnels
Display information about the current
L2TP sessions
Enable all L2TP information debugging
Disable all L2TP debugging
Enable L2TP control packet debugging
Disable L2TP control packet debugging
Operation
Operation
Operation
3Com Corporation
2-23
Chapter 2 Configuration of L2TP
Command
reset l2tp tunnel { remote-name | tunnel-id }
reset l2tp session session-id session-id
reset l2tp user user-name user-name
Command
tunnel flow-control
undo tunnel flow-control
Command
display l2tp user
display l2tp tunnel
display l2tp session
debugging l2tp all
undo debugging l2tp all
debugging l2tp control
undo debugging l2tp control