3Com 3C13636 Configuration Manual page 805

3Com Router 3000 Ethernet Family
Configuration Guide
[RTE-bgp] peer rtf next-hop-local
[RTE-bgp] ipv4-family multicast
[RTE-bgp-af-mul] peer 10.26.1.2 group rtf
[RTE-bgp-af-mul] peer rtf enable
[RTE-bgp-af-mul] peer rtf next-hop-local
[RTE-bgp-af-mul] quit
[RTE-bgp] quit
# Configure MSDP peer, Mess Group and Originating RP.
[RTE] msdp
[RTE-msdp] peer 10.29.1.1 connect-interface loopback 0
[RTE-msdp] static-rpf-peer 10.29.1.1
[RTE-msdp] peer 10.25.1.1 connect-interface loopback 0
[RTE-msdp] peer 10.27.1.2 connect- interface loopback 0
[RTE-msdp] peer 10.25.1.1 mesh-group net
[RTE-msdp] peer 10.27.1.2 mesh-group net
[RTE-msdp] originating-rp loopback0
[RTE-msdp] quit
[RTE] ip route-static 10.29.1.1 255.255.255.0 serial1/0/0
# Configure the candidate RP and BSR.
[RTE] pim
[RTE-pim] c-rp loopback 10
[RTE-pim] c-bsr loopback 0 30
3) Configure RTB:
# Enable multicast.
[RTB] multicast routing-enable
# Configure the IP address of interface Ethernet 0/0/0 and enable PIM-SM.
[RTB] interface ethernet 0/0/0
[RTB-Ethernet0/0/0] ip address 10.25.2.4 255.255.255.0
[RTB-Ethernet0/0/0] pim sm
[RTB-Ethernet0/0/0] undo shutdown
4) Configure RTG
# Enable multicast.
<RTG> system-view
[RTG] multicast routing-enable
# Assign an IP address to interface loopback0 and enable PIM-SM on it.
[RTG] interface loopback0
[RTG-LoopBack0] ip address 10.28.1.1 255.255.255.255
[RTG-LoopBack0] pim sm
[RTG-LoopBack0] quit
3Com Corporation
5-22
Chapter 5 MSDP Configuration