Executing A Modem Script Manually; Specifying The Events Triggering The Modem Scripts; Configuring The Modem Answer Mode - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide

3.2.3 Executing a Modem Script Manually

When necessary, you can use the start-script command to execute the designated
modem script to manage the external modem connected to the interface.
Perform the following configuration in user view.
Table 3-5 Execute modem script manually
Execute modem script manually

3.2.4 Specifying the Events Triggering the Modem Scripts

Associating the modem scripts with the events, as it implies, is to execute the
corresponding script automatically once a particular event occurs to the router.
Currently, the implementation supports only starting the dial script when starting a DCC
dial.
Perform the following configuration in user-interface view.
Table 3-6 Specify the events triggering the modem scripts
Specify
modem script at DCC dialing

3.2.5 Configuring the Modem Answer Mode

Use the modem auto-answer command depending on the answer state of the
connected external modem. When the modem is in auto-answer mode (AA LED of the
modem lights), configure the modem auto-answer command to prevent the router
from sending an answer instruction after the modem answers automatically. If the
modem is in non-auto answer mode, configure the undo modem auto-answer
command.
Note:
If the configuration of this command is not consistent with the current answer state of
the connected modem, anomalies may occur.
Perform the following configuration in user-interface view.
Operation
Operation
the automatically executed
3Com Corporation
Chapter 3 Modem Configuration
Command
start-script script-name number
script trigger dial script-name
3-5
Command