Configuring Svc-Based Mpls L2Vpn - 3Com 3C13636 Configuration Manual

Router 3000 ethernet family

Hide thumbs Also See for 3C13636:

Table of Contents

3Com Router 3000 Ethernet Family

Configuration Guide

The encapsulation type for the two CE interfaces is consistent and supported in current

For a MPLS L2VPN of VLAN encapsulation type, the VLAN IDs for the two CE

interfaces can be inconsistent.

4.7.2 Configuring SVC-Based MPLS L2VPN

I. Network requirements

Configure a remote SVC connection encapsulated with FR from CE1 at PE1 side to

CE2 at PE2 side.

To communicate normally, the DCE/DTE settings on CE1 and CE2 must match. On the

path CE1-PE1-PE3-CE4 in this scenario, set CE1 to DCE, PE1 to DTE, PE2 to DCE

and CE2 to DTE.

II. Network diagram

PE1:192.1.1.1

PE2:192.1.1.2

Figure 4-5 Network diagram for SVC-based MPLS L2VPN

III. Configuration procedure

Configure PE1

# Configure LSR ID, enable MPLS, LDP and MPLS L2VPN.

[3Com-mpls] mpls lsr-id 192.1.1.1

[3Com] mpls ldp

[3Com] mpls l2vpn

# Configure CE interface.

[PE1] interface serial3/1/0

[PE1-serial3/1/0] fr dlci 101

3Com Corporation

Chapter 4 MPLS L2VPN Configuration

Table of Contents

3c13636-us - router 3036 3000 series