3Com 3C13636 Configuration Manual page 798

3Com Router 3000 Ethernet Family
Configuration Guide
III. Configuration procedure
1) Configure RTB:
# Enable multicast.
<RTB> system-view
[RTB] multicast routing-enable
# Configure the IP address of interface Loopback0.
[RTB] interface loopback0
[RTB-LoopBack0] ip address 10.10.1.1 255.255.255.255
[RTB-LoopBack0] quit
# Configure the IP address of interface Loopback10 and enable PIM-SM.
[RTB] interface loopback10
[RTB-LoopBack10] ip address 10.1.1.1 255.255.255.255
[RTB-LoopBack10] pim sm
[RTB-LoopBack10] quit
# Configure the IP address of interface Serial1/1/0 and enable PIM-SM.
[RTB] interface serial 1/1/0
[RTB-Serial1/1/0] ip address 10.10.2.1 255.255.255.0
[RTB-Serial1/1/0] pim sm
[RTB-Serial1/1/0] undo shutdown
[RTB-Serial1/1/0] quit
# Configure the IP address of interface Serial1/0/0 and enable PIM-SM.
[RTB] interface serial 1/0/0
[RTB-Serial1/0/0] ip address 10.10.3.1 255.255.255.0
[RTB-Serial1/0/0] pim sm
[RTB-Serial1/0/0] undo shutdown
[RTB-Serial1/0/0] quit
# Configure OSPF.
[RTB] ospf
[RTB-ospf-1] area 0
[RTB-ospf-1-area-0.0.0.0] network 10.10.2.0 0.255.255.255
[RTB-ospf-1-area-0.0.0.0] network 10.10.3.0 0.255.255.255
[RTB-ospf-1-area-0.0.0.0] network 10.1.1.1 0.0.0.0
[RTB-ospf-1-area-0.0.0.0] network 10.10.1.1 0.0.0.0
[RTB-ospf-1-area-0.0.0.0] quit
[RTB-ospf-1] quit
# Configure RTA as its MSDP peer.
[RTB] msdp
[RTB-msdp] peer 10.21.1.1 connect-interface loopback 0
3Com Corporation
5-15
Chapter 5 MSDP Configuration