Configuration Of Mpls L2Vpn In Martini Mode; Configuring Ldp Remote-Peer; Creating A Martini Connection - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Delete an SVC connection
Caution:
You must guarantee the validity of transmit and receive labels of L2VPN in SVC mode.

4.4 Configuration of MPLS L2VPN in Martini Mode

Perform the following tasks to configure the MPLS L2VPN in Martini mode on a PE:
Configure interface
Enable MPLS L2VPN
Enable MPLS and configure LDP remote-peer
Configure PE-PE tunnel
Create a Martini connection
The first two steps are identical with those for CCC mode. See section 4.3
"Configuration of MPLS L2VPN in SVC Mode" for configuring PE-PE tunnel.

4.4.1 Configuring LDP Remote-Peer

LDP/MPLS L2VPN depends on the LDP remote-peer for VC label switching. Therefore,
before configuring a connection, you must enable LDP and configure the remote-peer
of LDP.
Refer to LDP Configuration of MPLS Module for configuring LDP remote-peer.

4.4.2 Creating a Martini Connection

IP address of the remote PE and VC ID are the two main parameters in the LDP
connection command. Where, the combination of VC ID and encapsulation type should
be unique on the PE.
Perform the following configuration in interface view.
Table 4-11 Create a Martini connection
Create a Martini connection
Delete a Martini connection
Operation
undo mpls static-l2vc
Operation
3Com Corporation
Chapter 4 MPLS L2VPN Configuration
Command
mpls l2vc ip-address vc-id
undo mpls l2vc
4-11
Command