3Com 3C13636 Configuration Manual page 1465

3Com Router 3000 Ethernet Family
Configuration Guide
Debugging message
DCC: peeraddr matching
error on
shutdown link
DCC:
interface *** , shutdown!
start enable-time
DCC:
wait-for-carrier-timeout on
a link on interface ***,
shutdown!start
enable-time
DCC: The interface has no
dialer-group, discard the
packet!
DCC: there is not a dialer
number on the interface,
failed, discard packet
DCC: Enable-timeout is
effective , failed
The local dialer route does
interface ***, not contain the remote
network address.
DCC normally disconnects
the connection whenever
idle-timeout on
the local DCC idle-timeout
timer
debugging message does
not indicate any error.
The local router cannot
contact the remote end for
a long time. The remote
end may be busy or the
quality of the phone line
may be bad.
The
command has not been
configured
corresponding
interface or the physical
interface on which DCC is
directly enabled.
Neither dialer route nor
the
configured
corresponding
interface or the physical
interface on which DCC is
enabled directly.
The enable-timeout timer
on
physical interface has not
timed out yet. The physical
interface can be used for
dialing upon the timeout of
the timer. This debugging
message does not indicate
any error.
3Com Corporation
Possible reason
times out. This
dialer-group
on the
dialer
dialer number is
on the
dialer
the corresponding
1-64
Chapter 1 DCC Configuration
Solution
Add the dialer
corresponding to
remote network address
on the local router or use
the dial number
removing all the dialer
routes configured on the
local router.
—
Check whether
remote end is busy.
Check the quality of the
phone line.
Refer to the previous
example to make
configuration.
Configure dialer route or
dialer number on the
local end for the outbound
call at the local end.
—
route
the
after
the
the