3Com 3C13636 Configuration Manual page 857

3Com Router 3000 Ethernet Family
Configuration Guide
IV. Display LSP
Please execute the following commands in any view to display the information related
to MPLS LSP.
Table 2-21 Display MPLS LSP
Display the information related to MPLS
LS
V. Debugging MPLS
You may execute the debugging command in user view to debug the information
concerning all interfaces with MPLS function enabled.
As enabling debugging may affect the router performance, you are recommended to
use this command unless necessary. Execute the undo form of this command to
disable the corresponding debugging.
Table 2-22 Debug MPLS
Enable debugging on various
MPLS LSP information.
Disable
debugging.
VI. Trapping MPLS
This command is used to enable the trap function of MPLS during an LSP/LDP setup
process.
Perform the following configuration in system view.
Table 2-23 Enable the trap function of MPLS
Enable the ldp trap function of MPLS
Disable the ldp trap function of MPLS
Enable the lsp trap function of MPLS
Disable the lsp trap function of MPLS
Operation
Operation
MPLS LSP
Operation
3Com Corporation
Chapter 2 MPLS Basic Capability Configuration
display mpls lsp [ verbose] [ include
text ]
Command
debugging mpls lspm { all | packet | event |
process | agent | interface | policy | vpn }
undo debugging mpls lspm { all | packet | event
| process | agent | interface | policy | vpn }
snmp-agent trap enable ldp
undo snmp-agent trap enable ldp
snmp-agent trap enable lsp
undo snmp-agent trap enable lsp
2-12
Command
Command