Setting The Unit Of Data Flows Destined For Radius Server; Configuring Source Address For Radius Packets Sent By Nas - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
RADIUS servers reject the username including ISP domain name. In this case, you
have to remove the domain name before sending the username to the RADIUS server.
3Com Router provides the following command to specify whether the username to be
sent to the RADIUS server carries ISP domain name or not.
Table 2-24 Set username format acceptable to RADIUS server
Set the username format transmitted to the
RADIUS server.
Note:
If a RADIUS scheme is configured not to allow usernames to include ISP domain
names, the RADIUS scheme shall not be simultaneously used in more than one ISP
domain. Otherwise, the RADIUS server will regard two users in different ISP domains
as the same user by mistake, if they have the same username (excluding their
respective domain names.)
By default, the username sent from NAS to the RADIUS server includes ISP domain
name.

2.3.10 Setting the Unit of Data Flows Destined for RADIUS Server

3Com Series Routers provide you with the following command to define the unit of the
data flow sent to RADIUS servers.
Table 2-25 Set the unit of data flows destined for RADIUS server
Operation
Set the unit of data flows
transmitted to RADIUS
server.
Restore the default unit.
In a RADIUS scheme, the default data unit is byte and the default data packet unit is
one packet.

2.3.11 Configuring Source Address for RADIUS Packets Sent by NAS

Perform the following configuration.
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Operation
data-flow-format data { byte | giga-byte | kilo-byte |
mega-byte } packet { giga-packet | kilo-packet |
mega- packet | one-packet }
undo data-flow-format
3Com Corporation
2-26
Command
user-name-format { with-domain |
without-domain }
Command
Configuration