Mpls Configuration Example - 3Com 3C13636 Configuration Manual

Router 3000 ethernet family

Hide thumbs Also See for 3C13636:

Table of Contents

3Com Router 3000 Ethernet Family

Configuration Guide

session: Displays debugging information in processing LDP session

pdu: Displays debugging information in processing PDU packets

notification: Displays debugging information in processing notifications

remote: Displays debugging information about all remote peers

2.5 MPLS Configuration Example

I. Network requirements

As shown in Figure 2-1, there is a network consisting of four 3Com router routers,

among which Router B and Router C are connected via SDH, and Router B, Router A

and Router D are interconnected via Ethernet.

The four routers all support MPLS, and LSP can be established between any two

routers with the routing protocol OSPF.

II. Network diagram

ethernet8/0/0

Figure 2-1 Network diagram

III. Configuration procedure

Configuration on Router A:

# Configure LSR ID and enable MPLS and LDP.

[3Com] mpls lsr-id 168.1.1.1

[3Com] mpls ldp

# Configure IP address and enable LDP for Ethernet interface.

[3Com] interface ethernet 8/0/0

[3Com-Ethernet8/0/0] ip address 168.1.1.1 255.255.0.0

[3Com-Ethernet8/0/0] mpls ldp enable

# Enable OSPF on the interfaces connecting Router A and Router B

[3Com] route id 168.1.1.1

ethernet1/0/0

ethernet1/0/1

ethernet2/0/1

3Com Corporation

Chapter 2 MPLS Basic Capability Configuration

Table of Contents

3c13636-us - router 3036 3000 series