3Com Router 3000 Ethernet Family
Configuration Guide
Create SVC connection
Refer to section 4.2 "Configuration of MPLS L2VPN in CCC Mode" for the first three
steps.
4.3.1 Configuring PE-PE Tunnel
Current two types of tunnels are available, GRE tunnel and LSP tunnel.
I. Configuring GRE tunnel
Table 4-8 Configure GRE tunnel
Create a tunnel interface
Configure tunnel source address (tunnel interface view)
Configure tunnel destination address (tunnel interface
view)
II. Configuring LSP tunnel
Table 4-9 Configure LSP tunnel
Configure LSP creation policy
Caution:
Since LSP is created by MPLS according to routing information, to create a LSP to the
destination address, first make sure host routing information of every PE is transmitted
to the peer by routing protocol.
4.3.2 Creating SVC Connection
Perform the following configurations in interface view.
Table 4-10 Create an SVC connection
Create
connection
Operation
Operation
Operation
mpls static-l2vc destination destination-router-id
an
SVC
transmit-vpn-label
receive-vpn-label receive-label-value
3Com Corporation
Chapter 4 MPLS L2VPN Configuration
Command
lsp-trigger { all | ip-prefix ip-prefix }
Command
4-10
Command
Interface tunnel num
source X.X.X.X
destination X.X.X.X
transmit-label-value