3Com 3C13636 Configuration Manual page 1429

3Com Router 3000 Ethernet Family
Configuration Guide
2) Implement the ISDN caller identification callback server in the C-DCC
Perform the following configuration in dial interface (physical or dialer interface) view.
Table 1-22 Implement ISDN caller identification callback (server configuration)
Configure the local end to implement
ISDN callback according to the ISDN
caller identification
Disable the local end to implement ISDN
callback according to the ISDN caller
identification
Configure the destination address(es)
and dial number(s) for calling one (or
more) remote ends
By default, callback according to ISDN caller identification is not configured.
Note:
The dialer route command configured on the dial interface (physical or dialer) at the
server should be exactly the same dialer route in the dial-in dialer number.
III. Implementing ISDN caller identification callback in the RS-DCC
1) Implement ISDN caller identification callback client in the RS-DCC
Perform the following configuration in dialer interface view.
Table 1-23 Implement ISDN caller identification callback (client configuration) in
RS-DCC
Configure the dial number for calling a
remote end
2) Implement the ISDN caller identification callback server in the RS-DCC
Perform the following configuration in dialer interface view.
Operation
Operation
3Com Corporation
1-28
Chapter 1 DCC Configuration
Command
dialer call-in
[ callback ]
undo dialer call-in remote-number
[ callback ]
dialer route protocol next-hop-address
[ mask network-mask-length]
dial-number [ autodial ]
Command
dialer number [ dial-number ]
remote-number