3Com 3C13636 Configuration Manual page 716

3Com Router 3000 Ethernet Family
Configuration Guide
By default, no configuration is performed.
Please note that if the routing information meets the match conditions specified in the
route-policy and also notifies the MED value configured with apply cost-type internal
when notifying the IGP route to the EBGP peers, then this value will be regarded as the
MED value of the IGP route. The preference configured with the apply cost-type
internal is lower than that configured with the apply cost command, but higher than
that configured with the default med command.
IV. Applying route-policy
Perform the following configuration in routing protocol view.
Table 7-8 Redistribute routes from other protocols
Configure to redistribute routes from
other protocols
Disable redistributing routes from other
protocols
By default, routing information from other protocols is not redistributed.
Note:
Different routing protocol views include different optional parameters. For specific
information, refer to the description of the import-route command corresponding to the
routing protocol in the manual.
For BGP, you can also configure route-policy of the peer group to control routes
redistributed from the peer/peer group or advertised to the peer group. Members of the
peer group cannot be configured with a outbound route update policy different from that
of the group, but can be configured with different inbound policies.
Table 7-9 Configure route-policy for a peer
Configure route-policy for a peer
Disable the route-policy of a peer
Operation
Operation
3Com Corporation
7-10
Chapter 7 IP Routing Policy Configuration
Command
import-route protocol [ med med | cost
cost ] [ tag value ] [ type 1 | 2 ]
route-policy route-policy-name
undo import-route protocol
Command
peer peer-address
route-policy-name import
undo peer peer-address route-policy
policy-name import
route-policy