3Com 3C13636 Configuration Manual page 813

3Com Router 3000 Ethernet Family
Configuration Guide
By default, no community attribute is advertised to any peer/peer group.
IV. Configuring a peer/peer group as an MBGP route reflector client
Table 6-6 Configure a peer/peer group as an MBGP route reflector client
Configure a peer/peer group as an
MBGP route reflector client
Remove the above configuration
By default, there is no route reflector in an autonomous system.
It is generally unnecessary to configure this command for a peer group. This command
is reserved for the occasional compatibility with the network equipments of other
vendors.
V. Configuring the local address as the next hop when advertising routes
This involves removing the next hop configuration in the routing information advertised
to a peer/peer group and configuring the local address as the next hop address. It is
valid only for IBGP peers/peer groups.
Table 6-7 Configure the local address as the next hop when advertising routes
Configure the local address as the next
hop when advertising routing information
Cancel the above configuration
VI. Transmitting only public AS numbers with BGP updates
Table 6-8 Transmit only public AS numbers with BGP updates
Transmit only public AS numbers with
BGP updates.
Transmit private AS numbers with BGP
updates.
By default, a private AS number is sent with BGP updates.
VII. Configuring the maximum times that the local AS number can be received
You may restrict the times that the local AS number is allowed to be present in the
received routing updates.
Operation
Operation
Operation
3Com Corporation
6-7
Chapter 6 MBGP Multicast Extension Configuration
Command
peer group-name reflect-client
undo peer group-name reflect-client
Command
peer group-name next-hop-local
undo peer group-name next-hop-local
Command
peer group-name public-as-only
undo peer group-name public-as-only