Setting Radius Server State; Setting Username Format Acceptable To Radius Server - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Table 2-22 Set the supported RADIUS server type
Set the supported RADIUS server type.
Restore the RADIUS server type to the default
setting.
By default, RADIUS server type is standard.

2.3.8 Setting RADIUS Server State

For primary and secondary servers (no matter they are authentication/authorization
servers or accounting servers) in a RADIUS scheme, if the primary server is
disconnected from the NAS due to some fault, the NAS automatically turns to the
secondary server. However, after the primary one recovers, the NAS does not resume
the communication with it at once; instead, the NAS continues communicating with the
secondary one and turns to the primary one again only after the secondary one fails. To
have the NAS communicate with the primary server right after its recovery, you can
manually set the primary server state to active.
When both primary and secondary servers are active or blocked, the NAS sends
packets to the primary one only.
Perform the following configurations in RADIUS view.
Table 2-23 Set RADIUS server state
Set the state of the primary RADIUS
authentication/authorization server.
Set the state of the primary RADIUS
accounting server.
Set the state of the secondary RADIUS
authentication/authorization server.
Set the state of the secondary RADIUS
accounting server.
By default, the state of each server in a RADIUS scheme is active.

2.3.9 Setting Username Format Acceptable to RADIUS Server

As mentioned above, the supplicants are generally named in userid@isp-name format.
The part following "@" is the ISP domain name. 3Com Series Routers will put the users
into different ISP domains according to the domain names. However, some earlier
Operation
Operation
3Com Corporation
2-25
Chapter 2 AAA and RADIUS/HWTACACS Protocol
server-type { huawei | standard |
portal }
undo server-type
Command
state primary authentication { block |
active }
state primary accounting { block |
active }
state secondary
{ block | active }
state secondary accounting { block |
active }
Configuration
Command
authentication