Enabling Mpls L2Vpn - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Table 4-4 Enable MPLS
Configure LSR ID
Enable MPLS
4.2.3 Configuring Static LSP
CCC makes use of static LSP for transparently transmitting L2 packets over an SP
network. Therefore, two static LSPs must be configured on the two PEs and all the
in-between P routers, with each in one direction.
Perform the following configuration in MPLS view.
Table 4-5 Configure a static LSP
Operation
Create an egress for
a static LSP
Remove the egress of
the static LSP
Create an ingress for
the static LSP
Remove the ingress
of the static LSP
Create a transit for
the static LSP
Remove the transit of
the static LSP

4.2.4 Enabling MPLS L2VPN

Perform the following configuration in system view.
Table 4-6 Enable MPLS L2VPN
Enable MPLS L2VPN
Operation
static-lsp egress lsp-name l2vpn incoming-interface
interface-type interface-num in-label in-label
undo static-lsp egress lsp-name l2vpn
static-lsp ingress lsp-name { l2vpn | destination ip-add }
{ nexthop
interface-type interface-num } out-label out-label
undo static-lsp ingress lsp-name l2vpn
static-lsp transit lsp-name l2vpn incoming-interface
interface-type interface-num } in-label in-label { nexthop
next-hop-addr
interface-num } out-label out-label
undo static-lsp transit lsp-name l2vpn
Operation
3Com Corporation
4-8
Chapter 4 MPLS L2VPN Configuration
Command
mpls lsr-id X.X.X.X
mpls
Command
next-hop-addr |
| outgoing-interface
Command
mpls l2vpn
outgoing-interface
interface-type