Configuring Session Parameters - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
II. Configuring a remote-peer address
You can specify the address of any LDP-enabled interface on the remote-peer or the
address of the loopback interface on the LSR that has advertised the route as the
address of the remote-peer.
Perform the following configurations in the remote-peer view.
Table 2-10 Configure a remote-peer address
Configure the remote-peer address
There is no default remote-peer.

2.3.4 Configuring Session Parameters

I. Configuring session hold-time
The LDP entity on the interface sends Hello packets periodically to find out LDP peer,
and the established sessions must also maintain their existence by periodic message
(if there is no LDP message, then Keepalive message must be sent).
Caution:
Modifying the holdtime parameter may re-establish the original session, as well as the
LSP over this session. Here the session refers to link session, but not remote session.
Perform the following configurations in the interface view.
Table 2-11 Set interface LDP session parameters
Set interface LDP session
keepalive parameters
Restore the default interface
LDP session parameters
The session-holdtime argument defaults to 60 seconds and the hello-holdtime
argument defaults to 15 seconds.
Operation
Operation
3Com Corporation
Chapter 2 MPLS Basic Capability Configuration
remote-ip ip-address
Command
mpls ldp timer { session-hold session-holdtime |
hello hello-holdtime }
undo mpls ldp timer { session-hold | hello }
2-7
Command