Adding An Ipsec Connection - 3Com OfficeConnect 3CR858-91 User Manual

Adding an IPSec
Connection
1 In the VPN screen, click Add, or click Edit to edit an existing connection.
2 At the Tunnel Type drop-down list, select IPSec. The screen shown in
3 Enter a descriptive name for the tunnel at the Tunnel Name text box.
4 At the Remote VPN Server drop-down list, select either IP Address or
5 At the Remote Party ID drop-down list, select either IP_IPV4_ADDR or
6 Type a name for the Remote Party ID in the text box next to the
7 Enter the Remote Network Address and Remote Subnet Mask for the
To add an IPSec Connection, or to edit an existing IPSec connection:
Figure 45 displays.
Figure 45 VPN Tunnel Configuration - IPSec Screen
ANY. If you select IP Address, enter the IP address or host name of the
remote server in the IP Address/Host Name text box. If you select ANY,
you do not need to specify an IP address or host name, as any remote
server can be used.
ID_USER_FQDN. This must be entered identically on the IPSec software
installed on the client's machine.
If you select IKE Main Mode from the Key Management drop-down list
(see step 8), you must enter IP_IPV4_ADDR here.
drop-down list. This must be unique for each connection rule that you
create.
Remote Party ID. The remote network address is usually the network
address of the LAN connected to the remote server.
VPN 67