Wheel Motors - Toro Field Pro 6040 Service Manual

Wheel Motors

Removing the Wheel Motor
Field Pro® 6040
22267SL Rev A
g412077
1. Elbow fitting (2 each)
2. Wheel motor
3. Flange nut (4 each)
4. Flange nut
If wheel motor hub removal is necessary (to replace the drive studs for example);
refer to the Hydro-Gear HGM-H™ Series Motor Service and Repair Manual
hub removal and installation information.
If the wheel motor is replaced in part or in whole, the traction control
linkage requires adjustment before returning the machine to service;
refer to Adjusting the Traction Speed (page
Refer toFigure 53 for this procedure.
1. Remove the rear wheel; refer to
(page 7–5).
2. Remove the fasteners securing the brake link to the brake actuator.
3. Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page
4. Clean the area around the hydraulic tube and fitting connections then
disconnect or remove the hydraulic tubes from the wheel motor. Cap or plug
the disconnected hydraulic tubes and fittings to prevent hydraulic system
contamination.
5. Support the wheel motor and remove the fasteners securing the wheel motor
to the frame, then remove the wheel motor from the machine.
6. If necessary, remove the hydraulic fittings from the motor. Record the
locations and orientations of the fittings for assembly purposes.
7. Remove and discard all the O-rings from the hydraulic tubes, and fittings
that were disconnected or removed.
Figure 53
(right side wheel motor shown)
5. Elbow fitting
6. Cap screw (4 each)
7. Brake link
8. Cap screw
IMPORTANT
Removing and Installing the Rear Wheels
Page 5–71
5–41).
General Precautions for
5–46).
Hydraulic System: Service and Repairs
for