Toro Field Pro 6040 Service Manual page 122

Charging the Hydraulic System (continued)
Hydraulic System: Service and Repairs
11. Lower the machine to the ground.
12. Operate the machine by gradually increasing its work load to full over a 10
minute period.
13. Stop the machine, check the hydraulic components for leaks and tighten
any loose connections.
14. Check and adjust the fluid level in the hydraulic reservoir if necessary; refer
to the traction unit Operator's Manual.
Note: If new fluid shows any signs of contamination, flush the hydraulic
system again until the fluid is clean; refer to
(page 5–49).
Page 5–56
Flushing the Hydraulic System
Field Pro® 6040
22267SL Rev A