Toro Field Pro 6040 Service Manual page 142

Installing the Control Valve
Hydraulic System: Service and Repairs
Refer to Figure 55 for this procedure.
1. Ensure that all control valve components are properly installed prior to
installing the control valve into the machine; refer to
Valve (page 5–77).
2. Fit the control valve to the machine and secure it with the previously removed
fasteners.
3. Remove the caps and plugs then connect the hydraulic tubes and hoses
to the control valve fittings; refer to
(O-Ring Face Seal Fitting) (page
4. Charge the hydraulic system; refer to
5–55).
Installing Hydraulic Hoses and Tubes
5–8).
Charging the Hydraulic System (page
Page 5–76
Servicing the Control
Field Pro® 6040
22267SL Rev A